Mobile Unit for Light Vehicles (Container)

The Mobile Unit for Light Vehicles (Container) from Ryme Worldwide, is designed to house the equipment necessary for the technical inspection of light vehicles.

It has 3 sections:

  • Administrative area: office to carry out the corresponding procedures.
  • Inspection area: located in the middle part of the unit, in which the different inspection tests are carried out.
  • Technical area: where the generator and the electrical panels that administer electricity to the entire mobile unit are located

ALL Step Aligner

Designed to carry out an effective verification of the geometry of the steering axles of vehicles up to 4T.

BSU Suspension Bench

Designed to perform quick and efficient analysis of suspension status of vehicles up to 4 T per axle, being able to withstand loads of up to 16 T in step.

Light Vehicle Brake Tester FRL

Its function is to carry out a complete verification of the braking system operation of light vehicles with MMA of up to 3,500 kg y 4 T per axle at step.

DHL Total Slack Detector

Check the axle status of vehicles and their components. Allows you to observe the possible wear and play caused by vehicles up to 18 T.

Gas Analyzer + Opacimeter RY-4000AGH

Our Gas Analyzer allows the measurement of up to 5 gases: CO, CO2, HC, O2, NOx (optional). The opacimeter is a flowmeter partial based on the principle of light absorption by smoke.

Digital Headlight Tester RY-RM

Electronic headlight tester Equipped with a camera for a complete analysis of any type of vehicle headlight.

Class 2 integrative sound level meter

Peripheral to perform measurements and checks of the Noise level produced by both vehicles and machines.

*The equipment shown is that recommended by Ryme for the configuration of the mobile unit, however it can be composed of other machines at the customer's request.